Honda Africa Twin Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-4 of 4 Results
  1. CRF 1000 Engine/Powertrain Technical Discussion
    Hello, the chain of my bike was too lose so I adjust it to specs (35-45 mm slack at Center of swing arm). All is in good condition (sprockets and chain). I put WD40 lube for chains with O-X-Z Rings compatibility. Now all works fine and the bikes behaves nicely but the only problem is that when I...
  2. CRF1000L/CRF1100 Africa Twin General Discussion
    The chain on the images has 15000 km wear i wonder if i should just change the damaged link or change the whole chain ❓ a new chain are not expensive but will it run properly on the chain wheels and are a clacic o-ring chain better
  3. CRF 1000 Engine/Powertrain Technical Discussion
    Hi Guys, I am getting close to a new chain and sproket set. Am considering dropping or adding a tooth to the back sproket. Main reason is that, as a commuter, I always feel the bike is revving a bit too much in 5th, and chuggs too much in 6th when doing 50-55kmh. If I drop a link, I feel I...
  4. CRF 1000 Wheels, Tires, Tubeless Setups
    I hope you guys can steer me in the right direction. I recently had a Shinko 705 put on the rear of my 18 Adventure Sport. I replaced a worn out 805. Now, whenever I hit exactly 46mph there is a high pitched hum or whining sound. It does not matter what gear I am in or what RPM am doing. It is...
1-4 of 4 Results
Top