Honda Africa Twin Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-2 of 2 Results
  1. Side fairing drilled

    Here are the holes drilled in the side fairing lower section. As mentioned the fairing has the three areas marked for the deflector mounting points. I used a small, 3mm drill bit to start the hole, drilled from the inside. Then thanks to the advice on this thread I used a step drill to enlarge.
  2. CFR1000L Africa Twin Parts & Accessories
    I bought this for my ATAS to help deflect wind around my 6'4", 230lb frame (sit a bit further back, and taller). The side buffeting is completely gone but it is 1-2" too short for me. I thought this was going to be the same height as the stock 18' ATAS screen, but turns out it is about the...
1-2 of 2 Results