Honda Africa Twin Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
105 Posts
The diameter of the OEM crash bar is 25 mm.
For your information I have included a photograph of the OEM bars which have four mounting points for their OEM lights (Only two are used) you can see where my lights are mounted and the same mounting points below. I removed one of the blanking plates which revealed it takes a M6 x by 15mm screw/bolt. The two bolt holes are 35 mm apart if you want to drill your own bracket. The attached thumbnail needs to be rotated 90 degrees right.
I hope this assists and good luck.
 

Attachments

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top