Honda Africa Twin Forum banner

21 - 31 of 31 Posts

Registered
Joined
2 Posts
Oh Oh - taking my windshield off the rubber covered nuts you screw the hold-down bolts into pushed inside the cowling. Do you have to take the whole front cowling apart to get them out? After that, how do you get the bolts started into the nuts when installing the windshield?
Do u know what size they are please I've just dropped 1 馃槩
 

Super Moderator
Joined
3,482 Posts
Do u know what size they are please I've just dropped 1 馃槩
 

Registered
Joined
15 Posts
As mentioned previously, you don鈥檛 need to fully remove the bottom two screws. Just loosen them, and with the top two screws removed, push screen down and then it should pull off. Hopefully the below picture helps to show what you鈥檙e dealing with. I know it would鈥檝e helped me!!
77C5270E-E47D-40EE-9537-DD825E28C4B1.jpeg
Yes
 

Administrator
Joined
1,893 Posts
I posted measurements in this thread. The most important ones are M5, 5mm. If the length or flange measurements are slightly off it won't really matter..


Sent from my SM-N975U1 using Tapatalk
 

Super Moderator
Joined
3,482 Posts
I posted measurements in this thread. The most important ones are M5, 5mm. If the length or flange measurements are slightly off it won't really matter..


Sent from my SM-N975U1 using Tapatalk
Heh, yeah, quoted in #22.
 

Administrator
Joined
1,893 Posts

Super Moderator
Joined
3,482 Posts
Still the same size :)

These are the ones I have ordered before:

Sent from my SM-N975U1 using Tapatalk
Totally agree. Unlikely the size has changed from less than a day ago. :)
 

Registered
Joined
12 Posts
I got rid of him too.
I managed to remove it with a piece of wire, guided by a video camera ;-)
Below I put a photo with what is written on it.
 

Attachments

21 - 31 of 31 Posts
Top