[ViperTech18]

Whow!!!!!!!
Interesting. You managed to open the Headlight.
My AT is a 22, USA Specs, and the dim lights are always ON.
I wondered how I can trick the wiring, to leave only the Halos on daytime, as the European Units.
Will study your pics to see if may be able to do something.

 

[ViperTech18]

Nope @Hood
Mi USA specs AT ONLY have volume adjust form RH Fn and LH adjust lever.
I can push/pull all day long these switches, only thing appears is Volume.
And the Dim plus Halos run ALL the time the Ignition switch is ON.
Now when install the Ezcan with the D4's, I want to have only the Halos and 30% from the D4 on Daytime.

 

[ViperTech18]

Yes, the light sensor works fine.
And yes, unfortunately we live in the same world, but different things in each place!
Even you drive in the wrong side of the road!!!!!!!

 

[ViperTech18]

now i am confused, 2 different pictures, the first one i got has 6 wires, this one has 4 wires, my connector has 5 wires and all of them have different wire-colors.

The thing here is this:
You are trying to match wire colors from the Manual to your opened Headlight.
The Manual depicts the wires FROM the Bike UP to the Connector.
Your Wires are INSIDE the Headlight.
Normally, NOBODY will see those wires on his lifetime.
Since they are inside, and nobody opens the expensive headlight each time.
Here only thing is to somebody take a PICTURE of the Bike's connector, so you can match it to your internal wires, and analyze and figure out your diagram, positions and function.
Later in the day I will see how easy is to disconnect this from my USA Specs 22', and post a picture.

 

[ViperTech18]

Interesting.
Following to know if removing the wire which powers Lo Beam will turn it off, and leave the DRL only ON.
Will do my testing as well, Once open the front of the bike.

 

[ViperTech18]

@Hood Good Morning.
Which P/N are the same?
The BCU or the Headlight?
I will check how many wires my Headlight have. Perhaps DRL and Low Beam are tied together inside the headlight on USA bikes.
In such case, nothing can be done to lit the DRL alone. And need to left them this way.
But, if there is 2 wires, I can interrupt the Low Beam one, with a switch.
This way, will turn off it on daylight, and leave DRL ON.
Will see.
👏

 

[ViperTech18]

Lo-beam and DRL are working.

Hi Andy.
Are you able to operate the Low Bean and DRL alone ?
I mean only one at the time?
Or they are tied together?
If yes, please let me know how.
Thank You.

 

[ViperTech18]

@Andy
In this post you wrote to NOT use Low and High Beam together, but I checked my '22 AT USA Specs, and the DRL and Low Beam are always ON, but when the High Beam is selected, the Low Beam DOES NOT TURN OFF.
It remain all 3 lighted.
Again, I would like to run only DRL on Daytime.
Or HALOS like they are called as well.

 

[ViperTech18]

Great!!!!!. Will wait for your diagram.
Thanks!